New York Brick Oven Company
N e w Y o r k B r i c k O v e n C o m p a n y t h e W o r l d ’ s B e s t O v e n s
1 7 1 8 H y l a n B l v d S t a t e n I s l a n d N e w Y o r k 1 0 3 0 5 ( 7 1 8 ) 9 8 7 - 2 4 2 2
The
“Spitfire” gas burner system is a sophisticated gas controller that can be
used in either a Manual or Automatic mode or with a Set Point. In addition, the
size of the flame can be regulated independently of the oven temperature.
Explanation of Gas Controls The System Power button (located in the
bottom right corner of the burner control panel ) Is to be turned on first.
POWER BUTTON (1)
The power switch is the button in the top left corner of the control box. A green
light will be illumined when the burner is on.
OVEN TEMPERATURE (4)
The oven temperature is display with LED numbers in the middle of the control
box. The Spitfire burner system reads the oven temperature in front of the burner
using a thermal couple. While this number is accurate, it is primarily used as
A guide for setting the burner not for cooking. See Cooking Environments for
details.
SET POINT (10)
The Set button is pressed to change the ‘Target temperature’ or set point of the
burner when in Auto mode. Press Set and then use the up and down arrows to
change the set point. Press set again to lock in the set point. The Spitfire burner
will automatically raise and lower the flame to maintain that temperature.
NOTE: The actual temperature inside the oven will be different than the
temperature displayed on the control box. This Set Point should be used in
conjunction with an infrared thermometer to balance the oven for the desired
cooking environment. Test various set points in 20 degree increments to
determine the set point that achieves the desired floor temperature.
RESET BUTTON (15)
If the oven loses its flame, the Reset button will be illumined. Press the Reset
button to relight the burner.
If the burner goes out three times in a row contact The New York Brick Oven
Company service department to help rectify the problem.
FIRE CONTROL
(
16-6
)
The size or intensity of the flame can be changed by pressing the up or down
arrows to achieve the desired flame.
MAX BUTTON (7)
Press the Max button to allow the oven to run at maximum power. The flame can
be adjusted manually by using the Fire Control up and down arrows.
AUTO BUTTON (9)
Press the Auto button to manage the oven based on the set point. See Set Point
for details.
Page 16
