New York Brick Oven Company
N e w Y o r k B r i c k O v e n C o m p a n y t h e W o r l d ’ s B e s t O v e n s
1 7 1 8 H y l a n B l v d S t a t e n I s l a n d N e w Y o r k 1 0 3 0 5 ( 7 1 8 ) 9 8 7 - 2 4 2 2
Gas Specifications
Gas Specifications
(gas models
MARKED “G “OR ‘GW”)
All New York Brick Oven Models are equipped with a 1/2" NPT gas connection.
Have a licensed gas installer provide the hook-up and test all fittings and pipe
connections for
leaks. Use
approved gas leak detectors (soap solutions or
equivalent) over and around the fittings and pipe connections.
The burner manifold pressures have been adjusted and tested at the factory. A
variety of factors can influence these pressures, so be sure to test the individual
burner manifold pressures and adjust the valves as necessary to achieve the
required pressures. Note: The gas valves are shipped in the 'on' position.
Gas Supply Pressure
Natural Gas: 5 to 8 inches WC
Propane (LP): 12 to 15 inches WC
LP (Propane) Use The gas supply must be turned
off at the L-P gas supply cylinder when this appliance is not in use.
the gas supply must be capable of providing at least 116,000 BTUs at listed
pressures.
171,000 for propane
The New York Brick Oven Company
recommends that the appliance’s individual
shutoff valve (supplied by others) be left readily accessible. The New York Brick
Oven Company also recommends that inspection and maintenance of the
burners and gas piping connections of this appliance be performed at regularly
scheduled intervals and only by professional gas appliance service agencies.
Gas Code Limitations
The installation of this appliance must conform with local codes, or in the
absence of local codes, with the National Fuel Gas Code, ANSI Z223.1
,
/NFPA 54
The Natural Gas installation Code CAN/CGA-B149.1 or the Propane Installation
Code, CAN/CGA-B149.2, as applicable including:
The appliance and its individual shutoff valve (supplied by others) must be
disconnected from the gas supply piping system during any pressure testing of
that system at test pressures in excess of 1/2 psi (3.45 kPa).
The appliance must be isolated from the gas supply piping system by closing its
individual manual shutoff valve (supplied by others) during any pressure testing
of the gas supply piping system at test pressure, equal to or less than 1/2 psi
(3.45 kPa).
Page 8
