New Leader L5034G4 AGCO, Руководство оператора

Страница: 38 / 86

- 38 -
www.NewLeader.com
(800) 363-1771
306375-AA-E
L5034G4 AGCO
Troubleshooting
Reason: Correction:
1� Hydraulic oil level low� Add hydraulic oil to reservoir to maintain level around
mid-point of sight gauge�
2� Shut Off valve on oil reservoir not open� Open valve fully by turning counter clockwise until it
stops�
3� Hydraulic Pump is not rotating� 1� PTO is disengaged� Shift into engagement�
2� Drive line has failed� Repair or replace�
3� Key in pump shaft has failed� Replace key�
4� U-joint pin or key has failed� Replace pin or key�
4� Worn pump� With flow meter arranged to check relief valve setting
above, open load valve fully. Read flow rate with truck
engine running at max RPM� Close load valve until
pressure reads 1000 PSI (69 bar)� Flow rate should not
decrease more than three (3) GPM. If flow loss is greater,
replace pump�
5� Conveyor relief valve open to return line� Using relief valve testing adapter and flow meter, test
valve for opening pressure� If not 3100 PSI (214 bar),
replace relief valve�
6� Jammed or frozen spinner motors� Free up� If not possible, replace as required�
7� Jammed or frozen conveyor� Free up conveyor�
8� Defective radar� Check speed on console� Repair or replace radar as
required�
9� Control processor’s power is in “Off”
position�
Turn on control processor�
Spinner motors do not turn when spinner control valve is in running position or conveyor does not run
when placed in “On” position� See reasons 1, 2, 3, 4, 6, 7, 8 & 9�
Spinners turn but conveyor does not run in manual mode� See reasons 5, 7, 9 & 10�
Console in operation mode, but the conveyor does not move when the machine moves� See reasons 5,
7, 9 & 10�
Spinner speed does not stay constant� See reasons 4, 8, 11, 12 & 13�
Spinners run with cab control in “Off” position� See reason 14�
Hydraulic oil overheats (200° F (93�33° C) or hotter)� See reasons 1, 5, 8, 15, 16, 17 & 18�
Light flashes and buzzer sounds intermittently. Conveyor runs in jerks. See reasons 19.
Conveyor does not run with cab control “On”, PTO engaged and vehicle driving forward� See reasons 20�
Conveyor runs when control switch in cab is in “Off” position� See reasons 15�
Conveyor starts to run when PTO is engaged� See reasons 15, 20�
Controller application or programming� Refer to the control manual’s Troubleshooting section�