P l e a s e G i v e P a r t N o . , D e s c r i p t i o n a n d U n i t S e r i a l N o .
HIGHWAY EQUIPMENT COMPANY
24
97372-B
Page Rev. A
INSTALLATION INSTRUCTIONS CONTINUED
Figure 3 - Mounting Angle Installation
Installing Rear Mounting Angles
Position rear mounting angles with the slotted faces against the side of the truck frame and centered on
rear cross sill. Mark slot locations on truck frame. Drill 9/16" diameter holes through truck frame at
bottom end of slots (Figure 3). Weld mounting angle to bottom of cross tube on three sides (Figure 4).
Install hardware and tighten to recommended torque.
Make sure drill will not puncture gas tank or harm any other obstruction
before drilling holes.
CAUTION
DO NOT WELD ON VEHICLE FRAME! Such welding can lead to
fatigue cracking and must be avoided.
IMPORTANT!
Содержание L3020G4
