New Holland E485C, Руководство по обслуживанию

Страница: 21 / 31

GENERAL
E485C
W5-1-17
Handling of liquid gasket
JP30ZDE010102007
1. Application of liquid gasket and part assembly procedure
(1) Remove old liquid gasket on each part and mating part completely. Clean the parts with a rag to prevent
deposit of oil, moisture, dirt, etc.
Be sure to overlap parts at the beginning and at the end of application.
(2) Be careful for offset with the mating part when a part applied with liquid gasket is assembled. Apply the
liquid gasket again if offset occurs.
(3) Assemble parts within 20 minutes after application of the liquid gasket.
If 20 minutes has passed, remove the liquid gasket and apply it again.
(4) Start the engine at least 15 minutes or more after assembly of parts.
2. Removal of parts
(1) When parts are removed, do not pry one place only. Remove parts by prying each other using collar or
clearance on the flange. When gasket is removed, be careful to prevent entry of gasket offal into the
engine.
3. Others
(1) When the liquid gasket is contained in a tube, use the accompanying winding tool. When it is contained in
a cartridge, use the application gun.
For a tube, desired application width may be obtained from the cut position at the nozzle end.
General information Description of function
1 : Approx. 2 mm at the 1st section cut
2 : Approx. 5 mm at the 2nd section cut
Winding tool
Tube: 150 g
Application gun
Cartridge type: 300 g
Nozzle of tube