ENG-5
ENG-6
Power Supply
Connect AC power
Caution:
Risk of product damage! Ensure that the power supply voltage corresponds to the voltage printed on the
rating label located on back or bottom of the unit.
Warning:
Risk of electric shock! When you disconnect the AC power, always pull the plug from the wall outlet.
Note:
Install the unit near the wall outlet and where the AC power plug can be easily reached.
1. Connect the power cord to the
AC IN
jack on the unit and to the wall outlet.
2. To save energy: After use, set the switch to
OFF
.
Install batteries (not included)
Note:
You can use both batteries and AC power as power supply of this unit.
Batteries are not supplied with the accessories.
1. Open the battery compartment.
2. Insert 8 x UM-2 batteries with correct polarity (+/-) as indicated.
3. Close the battery compartment.
Handling the batteries
·
Install the batteries correctly by following the polarity (+ and -) indications in the battery compartment.
·
Never use batteries that show signs of electrolyte leaks or cracking.
·
Never dispose of used batteries in an open fire.
·
Keep batteries out of reach of children.
·
Never recharge disposable batteries.
·
Never short circuit battery terminals.
·
Always remove used batteries from the appliance case.
·
Do not try to open the batteries.
·
Do not mix up different kind of batteries or new and already used batteries together.
·
Only use batteries of the recommended or equivalent type.
·
Remove batteries from the unit before disposing of it at the end of its service life.
·
Do not dispose of the end of the used batteries as domestic waste. Dispose of them in accordance with
local regulations.
Note:
When replacing the batteries, make sure you dispose of the old batteries in accordance with applicable
regulations. They should be disposed of in a location specifically designated for that purpose so they can
be recycled safely and without posing any risk for the environment. Do not burn or bury them.
General Operation
1. To switch on and select your operation source, adjust the
Function Selector
to
CD/MP3/USB
or
RADIO
.
2. Adjust the sound with the
Volume Control
.
3. To switch off the unit, adjust the
Function Selector
to
OFF
.
Note:
To avoid unnecessary energy consumption, always adjust the
Function Selector
to
OFF
after using
the unit.
Radio Reception
1. Adjust the
Function Selector
to
FM
.
2. Press
SKIP+/SKIP-
buttons to select the desired stations.
3. Press
STOP(FM MONO/STEREO)
to change FM Mono or FM Stereo.
Note:
If FM Stereo station, the display will show "ST".
Helpful hints:
·
To improve FM reception, you can extend, incline or turn the telescopic antenna for best reception.
Storing and using preset stations
You can store up to 10 FM radio stations in the memory.
1. Press
MEMORY
button in 2 seconds, the "
P01
" and "
MEMORY
" will
flash on the display.
2. Press
SKIP+/SKIP
- buttons to select the desired station then press
MEMORY
button to save.
3. Repeat steps 1-2 to enter additional stations into the program memory.
Note:
If
Using earphones
Turn down the volume before connecting the earphones. Slowly raise the volume with the earphones on
until you reach your desired volume. When earphones are connected, the speaker is automatically
disabled.
Note:
Avoid listening to sound at excessive levels which could be harmful to your ears. At full power, th
prolonged listening can damage the ears of the user.
10 preset station is set, press
MEMORY
button again, the display will show
P01
again.
If press SKIP+/SKIP- button to select the desired station, the previous P01 memory will overwrite.
FM
MHz
ST
.
MEMORY
MEMORY
FM
MHz
ST
.
FM
MHz
FM
MHz
FM
MHz
ST
.
ENG-4
