Maintenance
Clean the cabinet
Use a soft slightly moistened with a mild detergent solution. Do not use a solution containing alcohol,
spirits, ammonia or abrasives.
Clean discs
When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the centre out.
Do not use solvents such as benzene, thinner, commercially available cleaners, or antistatic spray
intended for analogue records.
Clean the disc lens
After prolonged use, dirt or dust may accumulate at the disc lens. To ensure good play quality, clean the
disc lens with camera lens brush or any commercially available cleaners. Follow the instructions supplied
with cleaner.
ENG-9
ENG-10
Troubleshooting
Environmental information
All unnecessary packaging materials has been omitted. The packaging can be easily separated into three
materials: cardboard, polystyrene and plastic.
Your set consists of materials which can be recycled if disassembled by a specialized company. Please
observe the local regulations regarding the disposal of packaging, dead batteries and old equipment.
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following hints, consult your dealer or service center.
Note:
Do not open the unit as there is a risk of electric shock. Under no circumstances should you try to
repair the set yourself; as this will invalidate the guarantee.
No power
·
Ensure that the power cord is connect securely.
·
Ensure that there is power at the AC Mains.
·
Ensure that the batteries are inserted correctly.
No sound or poor sound
·
Adjust the volume.
No response from the unit
·
Disconnect and reconnect the AC power cord, then turn on the unit again.
·
Electrostatic discharge, re-connect the AC power cord after a few seconds.
No disc detected
·
Insert a disc.
·
Check if the disc is inserted upside down.
·
Wait until the moisture condensation at the lens has cleared.
·
Replace or clean the disc.
·
Use a finalized CD or correct format disc.
The CD skips tracks
·
Ensure that the CD is not damaged or dirty.
·
Ensure that program mode is deactivated.
Poor radio reception
·
Increase the distance between the unit and your TV or any home appliance.
·
Fully extend the telescopic antenna.
ENG-4
