Neuropex ENT001, Руководство по эксплуатации

Страница: 11 / 20

3. Place electrodes on the skin
Place the electrodes on the skin as recommended by your
physician/clinician.
4. Insert Lead Wire Connector to TENS device
Plug end of lead wire into the channel output receptacle to be
used, pushing plug in as far as it will go.
5. Select Treatment Settings
Check and be sure your unit is still set to the proper settings
recommended by your physician/clinician.
6. Adjusting Channel Intensity Control
Locate the intensity control knob at the top of the unit. Turn
channel 1 or 2 clockwise. The indicator light will light up as
long as the unit is in operation. Slowly turn the channel control
in a clockwise direction until you reach the intensity recom-
mended by your physician/clinician. Repeat for the other
channel if both channels are to be used.
If the stimulation levels are uncomfortable or become uncom-
fortable, reduce the stimulation amplitude to a comfortable
level or cease stimulation and contact your physician if
problems persist.
BATTERY INFORMATION
If your TENS device is equipped with a rechargeable battery
system, it will contain two rechargeable Ni-Cad batteries and a
battery charger. This allows you to charge one battery while
the other one is being used in your unit. To protect the life of
your batteries, it is important to continue using a battery until
the indicator light is no longer lit. Removing the battery and
charging it after only a short usage can actually shorten the life
of the Ni-Cad battery.
When the indicator light located on the front of the unit will no
longer light, the battery has become too weak to power the unit
and it is time to charge the battery. At this point the unit will
shut off until a fresh battery is inserted.
Your unit may also be powered by a 9 volt disposable alkaline
battery. This type of battery cannot be recharged and should
be discarded when the yellow light no longer lights.
07