Neumaerker 12-40424 DT, Руководство по эксплуатации

Страница: 3 / 18

2.2.1 Responsibilities of the operator
Warnings
The manufacturer can not be held liable if damage is caused by failure to
observe the following instructions:
1.To deal with this device and all electrical equipment, the rules of safety must
always be followed.
In particular:
- Do not expose the unit to rain or moisture.
- This device is not intended to be used by persons (including children) with restricted
physical, sensory or mental faculties or due to a lack of experience and / or lack of
knowledge, unless they are supervised by a person responsible for their safety, how
the device is to be used. Children should be supervised to ensure that they do not
play with the appliance.
2. After unpacking, make sure that the unit has not been damaged. In case of doubt,
do not operate the unit and inform our service.
Keep packaging materials (plastic bags, styrofoam, nails, etc.) out of the reach of
children and pets,
these parts constitute a source of danger!
3. Use the appliance only for the specified purpose.
4. Before the connection, check that the information on the type plate matches the
values of the installation. The basic safety regulations must be complied with. In case
of doubt, a qualified specialist must verify the installation. Electrical safety is only
guaranteed if the device has been correctly installed and a potential equalization has
been established as described in the safety regulations for electrical installations.
5. For all maintenance and servicing work, the device must be disconnected from the
mains before switching off the main switch, or disconnecting the mains supply.
6. Do not leave the appliance unattended during operation. Do not leave the
appliance switched on for a long period of time after use. Do not use the appliance as
a room heating system. Switch off the main switch (2).
7. As soon as a malfunction or an error is detected, the device must be disconnected
from the mains. Repairs may only be carried out by a qualified specialist or our
customer service.
2.3 Environmental information
Disposal of the device
Devices must be made unusable prior to end-of-life monitoring by removing the
mains cable. Ensure that the device is environmentally save and properly disposed.
2.4 Legal information
Please read the operating instructions carefully before starting work, especially
before first use usage (chapter 8.3). The manufacturer assumes no responsibility for
improper handling of the device. Check the unit for visible damage. In case of
damage of any kind, please notify the customer service (chapter 2.6). The operating
instructions are to be stored for all persons who work with the device freely
accessible. The manufacturer reserves the right to make technical modifications and
further developments on his devices without prior notice.