NEULOG COLORIMETER LOGGER SENSOR GUIDE
13.
To set the colorimeter sensor’s settings click on “Module setup” button
located on the colorimeter sensor icon on the left side of your screen.
14.
To change the experimental settings click the “Experiment setup” button
(experiment duration for example).
15.
To run an experiment and collect data click “Run experiment”.
Operation with NeuLog viewer
Materials needed:
NUL-219 Colorimeter Sensor
Cu Cuvette Lids
VIEW-101 Viewing Module
BAT-200 Battery
Procedure:
1.
Connect the colorimeter sensor to the left side of the viewer.
2.
Connect the BAT-200 module to the right side of the viewer.
3.
The VIEW-101 will auto detect the sensor and you will see it appear on the
left side of the screen.
4.
Once the sensor appears it will be monitoring data in real time.
5.
To run an experiment and collect data click the run button (little green
person).
Off-line experiments
(Off-line experiments are for when you do not have a sensor connected directly to a
computer, tablet, smartphone, or NeuLog viewer).
Materials needed:
NUL-219 Colorimeter Sensor
Cu Cuvette Lids
BAT-200 Battery
Materials needed to configure your offline experiment:
USB-200 USB Module or WIFI-201 WIFI module or VIEW-101 Viewing Module
A USB to mini USB cable (which comes with the USB-200)
Procedure:
1.
Connect the colorimeter sensor directly to the left side of a charged BAT-
200 module.
2.
When ready to collect data press the “Start/Stop” button on the colorimeter
sensor, a red light will turn on for the duration of the experiment.
3.
To change the experiment settings first connect to your chosen device (PC,
Mac, tablet, smart device) and select the “Module setup” button. (For more
information on how to change the experiment settings view quick start
procedure section for your chosen device in this document.)
4.
After the experiment has concluded (when the “Start/Stop” button is pressed
again or the data collection period ends) connect the sensor to your chosen
device. (full instructions in each device’s quick start procedure section)
5.
Open NeuLog software.
6.
Click the “Off-line experiment” button.
7.
Click the “Load data from sensors” button.
8.
Select which experimental data to upload. (5 experimental runs can be
stored at one time on the NUL-219 colorimeter sensor)
Restoring
sensor’s factory default settings:
Procedure:
1.
Connect the USB-200 to a PC, Mac, tablet, or smart device.
2.
Connect the colorimeter sensor to a USB-200 module (they directly plug
together). Please note there is no calibration required for this sensor.
3.
Open the NeuLog software.
4.
Click the “Tools” icon.
5.
Click “Restore sensor’s factory defaults” icon.
6.
If prompted to clear the graph, click either the “Off-line experiment” or “On-
line experiment” (whichever you are using).
7.
Click “Clear experiment results”.
8.
Resume from step 4.
Included with sensor:
Three plastic cuvettes with three lids.
Neulog NUL-219 Colorimeter sensor Guide (This Document)