Neue SFO1SS, Руководство пользователя

Страница: 11 / 16

Cleaning the door gasket
• Regularly do a check of the door gasket. The door
gasket is around the frame of the oven cavity. Do not
use the appliance if the door gasket is damaged.
Contact the Service Centre.
• To clean the door gasket, refer to the general infor-
mation about cleaning.
Oven lamp
Warning! Be careful when you change the oven
lamp. There is a risk of electrical shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or deactivate the
circuit breaker.
Put a cloth on the bottom of the oven to prevent
damage to the oven light and glass cover.
1. Turn the glass cover counterclockwise to remove
it.
2. Clean the glass cover.
3. Replace the oven light bulb with an applicable 300
°C heat-resistant oven light bulb.
Use the same oven lamp type.
4. Install the glass cover.
Cleaning the oven door
The oven door has two glass panels. You can remove
the oven door and the internal glass panel to clean it.
The oven door can close if you try to remove the
internal glass panel before you remove the oven
door.
Caution! Do not use the appliance without the
glass panels.
1
Open the door fully
and hold the two door
hinges.
2
Lift and turn the lev-
ers on the two hinges.
3
Close the oven door
to the first opening posi-
tion (halfway). Then pull
forward and remove the
door from its seat.
4
Put the door on a soft
cloth on a stable surface.
5
Release the locking
system to remove the in-
ternal glass panel.
90°
6
Turn the two fasten-
ers by 90° and remove
them from their seats.
1
2
7
Carefully lift (step 1)
and remove (step 2) the
glass panel.
Clean the glass panel with water and soap. Dry the
glass panel carefully.
Installing the door and the glass panel
When the cleaning is completed, install the glass panel
and the oven door. Do the above steps in the opposite
sequence.
The screen-printing zone must face the inner side of the
door. Make sure that after the installation the surface of
the glass panel frame on the screen-printing zones is
not rough when you touch it.
11