LIS-SDI Rev.
2
network-electronics.com
|
18
9.5 Get and Set
These commands are factory internal. The end-user should avoid these commands:
Status of
Status string
Comment
No SDI input
SDI input is not detected.
SDI signal strength > 90 %
Strong SDI signal.
SDI signal strength < 10 %
Weak SDI signal.
SDI input
SDI signal strength =
%d
%
%d
is a number from 10 to 90.
No BBurst input
No Black&Burst detected.
BBurst detected not locked
LIS-SDI is unable to synchronize the analog output to
the detected Black&Burst input. The Black&Burst
signal may be out of LIS-SDI's frequency range.
Black&Burst
BBurst detected and locked
LIS-SDI generates analog output synchronized to the
detected Black&Burst input signal.
EDH insertion disabled
No EDH information in SDI output.
EDH
(No EDH status string)
EDH information is included in SDI output.
Locked to Bburst line:
xxx
,
sample:
xxxx
xxx
is an integer from 0 to 624 and
xxxx
is an integer
from 0 to 1727. This line indicates that the card is in
Lsync mode.
Delay
Lsync disabled, delay ref. to BB
line:
xxx
, sample:
xxxx
The card is not in Lsync mode and is used as a
deglitcher. Black&Burst is not used as an output
timing reference, only as a frequency reference. The
xxx
and
xxxx
shows what the reference would have
been if lsync were enabled.
TRS Replace on
The incoming video SYNC words are replaced with
the SYNC words generated by the internal video
generator.
TRS Replace
(No TRS Replace string)
The incoming video SYNC words are used as it is.
Video standard 625
The video standard is 625 lines/50Hz
Video
standard
Video standard 525
The video standard is 525 lines/60Hz
No EDH:
%d
Count fields where EDH is absent.
Error full field:
Label to present next 7 lines as “full field”-error
counters.
crc:
%d
Full field CRC-error is detected here.
unk:
%d
Unknown status-flag is detected.
ues:
%d
Unknown error status-flag is detected.
ida:
%d
Internal error detected already-flag is detected.
idh:
%d
Internal error detected here-flag is detected.
eda:
%d
Error detected already-flag is detected.
edh:
%d
Error detected here-flag is detected.
Error active video:
Label to present next 7 lines as “active video”-error
counters.
crc:
%d
Active video CRC-error is detected here.
unk:
%d
Unknown status-flag is detected.
ues:
%d
Unknown error status-flag is detected.
ida:
%d
Internal error detected already-flag is detected.
idh:
%d
Internal error detected here-flag is detected.
EDH
eda:
%d
Error detected already-flag is detected.
