FR-2RU-10-2
Rev.
8
15
Figure 13: Inserting module cards
Slide the card into the plastic guide rails inside the sub-rack until the red
handle is close to the sub-rack front. A detailed description of the last part of
the insertion process is shown in figure 14.
Figure 14: Inserting module cards (continued)
On the top of the rack is a hole above each module slot. When the tip of the
handle is just below this hole (fig. 14 a)), start to bend the handle downwards
as in figure 14. The tip of the handle enters the hole and the card is locked
and proper contact ensured when the handle is in upright position (figure 14
b)).
Make sure that the connector on the module card fits with the connector on
the back plane card when inserting a new module card for the first time.
