FR-2RU-10-2
Rev.
8
11
5
Sub-rack operation
In order to reconfigure or expand the number of modules within a sub-rack,
the front panel must be removed. Each module has a corresponding
connector module at the rear, and is hot swappable.
5.1
Removing the front panel
Detach the front panel by putting your fingers on the right hand side of the
front panel and pull gently, as shown in the figures below. Then pull the front
panel slightly to the right before removing it.
Hold here Pull here
"Left circle" "Right circle"
Figure 7: Removing the front panel.
A more detailed description of how the front panel is detached is given in
figure 8.
Step 1 looks at the details in the "right circle" seen from the right hand side,
whereas the next two steps (step 2 and step 3) gives the details of the "left
circle" as seen from the top.
Note!
Use safety goggles when hot-swapping module cards.
If a receiver card is removed from the sub-rack, an invisible laser
beam may be emitted inside the sub-rack from the laser at the
other end. The laser beam might be harmful to your eyes
.
