5
5.
Data Report
Function Key
Press and Hold for 5 Seconds
Restore to the original setting / Turn off
The green indicator flashes 20 times: success
The green indicator remains off: fail
Press once
The device is in the network: the green indicator flashes once and the device sends a data
report (It would take 35 seconds for the sensor to sample and process the collected value after
pressing the button)
The device is not in the network: the green indicator remains off
After power on, the device will immediately send a version packet report and data.
The device sends data according to the default configuration before any other configuring.
ReportMaxTime:
RA0701 and RA0701Y is 180s,
R72601 is 900s (subject to original setting)
ReportMinTime:
30s
ReportType count:
1
ReportChange:
0
* ReportChange is not supported by RA0701_R72601_RA0701Y (Invalid configuration).
* The value of the ReportMaxTime should be greater than ReportType count *Report10
Note:
(1) The device also supports the TxPeriod cycle configuration instructions of Cayenne. Therefore, the device can
perform the report according to the TxPeriod cycle. The particular report cycle is ReportMaxTime or TxPeriod
depending on which report cycle was configured last time.
(2) It would
take 35 seconds
for the sensor to sample and process the collected value after pressing the button,
please be patient.
(3) Data pocket: CO
The device reported data parsing please refer to Netvox LoRaWAN Application Command document and Netvox Lora
Command Resolver
