5
Sleeping Mode
The device is on and in the
network
Sleeping period: Min Interval.
When the reportchange exceeds the setting value or the state changes, a data report will be sent
according to Min Interval.
Low Voltage Warning
Low Voltage
3.2V
*
Suggest removing batteries if the device is not used to save
the power.
5. Data Report
Data report configuration and sending period are as following:
Min Interval
(Unit:second)
Max Interval
(Unit:second)
Reportable Change
Current Change≥
Reportable Change
Current Change
＜
Reportable Change
Any number between
1~65535
Any number between
1~65535
Can not be 0.
Report
per Min Interval
Report
per Max Interval
After power on, the device will immediately send a version packet report and a data report including the attribute.
The device sends data according to the default configuration before any other configuring.
Default setting:
MaxTime: Max Interval = 60 min = 3600s
MinTime: Max Interval = 60 min = 3600s
BatteryChange = 0x01 (0.1v)
Temperature Change = 0x0064 (1°C)
Humidity Change = 0x0064 (1
%
)
Note:
(1)
The device report interval will be programmed based on the default firmware which may vary.
(2)
The interval between two reports must be the minimum time.
Please refer Netvox
LoRaWAN Application Command document
and
Netvox Lora Command Resolver
