9
6. Installation
This product comes with waterproof function.
When using it, the back of it can be adsorbed on the iron surface, or the two ends can be fixed to the
wall with screws.
1.The Wireless Water Leak Detector (R718WA)
has a built-in magnet (as Figure 1 below).
It can be attached to the surface with iron material
during installation.
To make the installation more secure, please use
screws (purchased separately) to fix the device on
the wall or other objects (as Figure 2 below).
Comment
Do not install the device in a metal shielded box
or in an environment surrounded by other
electrical equipment to avoid affecting the
wireless transmission of the device.
3. When the sensor probe detects the leak, the
device will send an "alarm" message.
After remove the probe from the accumulated
leakage and drain the remaining water from
the sensor, the device will restore to the
"normal" state and send the "normal" status
message.
2. Remove the 3M release paper (as the red
part of the above figure) on the back of the
sensor probe and attach it to the smooth
ground that may accumulate leakage (as the
right figure).
