5
Trigger:
When the R718F2 status changes, it will send warning report.
Reed switch sensor open:1
Reed switch sensor close:0
Note:
1. The device data sending cycle depends on the burning configuration before shipment.
2. The interval between two reports must be the minimum time.
Data report configuration and sending period are as following:
5. Restore to Factory Setting
R718F2 saves data including network key information, configuration information, etc. To restore to
factory setting, users need to execute below operations.
1.
Press and hold function key for 5 seconds till the green indicator flashes and then release; LED
flashes quickly 20 times.
2.
R718F2 is at mode by default setting after restoring to factory setting.
Note: The device operation of turning off is the same as the device restore factory settings.
6. Sleeping Mode
R718F2 is designed to enter sleeping mode for power-saving in some situations:
(A) While the device is in the network → the sleeping period is Min Interval. (During this
period, if the reportchange is larger than setting value, it will wake up and send a data report).
(B) When it is not in the network → R718F2 will enter sleeping mode and wake up every 15
seconds to search a network to join in the first two minutes. After two minutes, it will wake up
every 15 minutes to request to join the network.
If it’s at (B) status, to prevent this unwanted power consumption, we recommend that users remove
Min Interval
(Unit:second)
Max Interval
(Unit:second)
Reportable
Change
Current
Change≥
Reportable Change
Current
Change
＜
Reportable Change
Any
number
between 1~65535
Any
number
between 1~65535
Can not be 0.
Report
per Min Interval
Report
per Max Interval
