10
Notes :
1)
The device only wakes up and performs data sampling according to MinTime Interval. When it is sleeping, it does not
collect data.
2)
The data collected is compared with the last data reported. If the data variation is greater than the ReportableChange value,
the device reports according to the MinTime interval. If the data variation is not greater than the last data reported, the
device reports according to the MaxTime interval.
3)
We do not recommend setting the MinTime Interval value too low. If the MinTime Interval is too low, the device wakes
up frequently and the battery will be drained soon.
4)
Whenever the device sends a report, no matter resulting from data variation, button pushed, or MaxTime interval, another
cycle of MinTime/MaxTime calculation is started.
6. Example Application
In the case of detecting if the generator is working normally, it is recommended to install R718EC horizontal while the generator
is power-off and in static status. After installing and fixing R718EC, please turn on the device. After the device is joined, one
minute later, R718EC would perform the calibration of the device (the device cannot be moved after the calibration. If it needs to
be moved, the device needs to be turned off/powered off for 1 minute, and then the calibration would be performed again).
R718EC would need some time to gather the data of the three-axis accelerometer & the temperature of the generator while it is
working normally. The data is a reference for the settings of ActiveThreshold & InActiveThreshold, it is also for checking if the
generator is working abnormally.
Assuming that the collected Z Axis Accelerometer data is stable at 100m/s², the error is ±2m/s², the ActiveThreshold can be set to
110m/s², and the InActiveThreshold is 104m/s².
Note:
Please do not disassemble the device unless it is required to replace the batteries.
Do not touch the waterproof gasket, LED indicator light, or function keys when replacing the batteries. Please use a suitable
screwdriver to tighten the screws (if using an electric screwdriver, it is recommended to set the torque as 4kgf) to ensure the
device is impermeable.
