7
Notes :
1) The device only wakes up and performs data sampling according to MinTime Interval. When it is sleeping, it does not collect data.
2) The data collected is compared with the last data reported. If the data variation is greater than the ReportableChange value, the device reports according to MinTime interval. If the data
variation is not greater than the last data reported, the device reports according to MaxTime interval.
3) We do not recommend to set the MinTime Interval value too low. If the MinTime Interval is too low, the device wakes up frequently and the battery will be drained soon.
4) Whenever the device sends a report, no matter resulting from data variation, button pushed or MaxTime interval, another cycle of MinTime/MaxTime calculation is started.
6. Example Application
In the case of detecting whether the motor is working normally, it is necessary to install the device in the state where the device is powered off and the
motor is stationary. It is recommended to install it horizontally. After the fixing is completed, power on the device. The device performs offset
calibration of the device after one minute of network-joining. (The device offset cannot be moved after calibration. If it needs to be moved, it needs to
be powered off for 1 minute and then re-offset calibration). The equipment needs to collect the triaxial acceleration and temperature of the target motor
for a period of time, and it is used as a reference for the setting of the static threshold, the motion threshold and whether the motor is abnormal. Assume
that the acquired Z-axis acceleration is stable at 100m/s
2
with an error of
±
2m/s
2
, and the active threshold can be set to 110m/s
2
, and the static
threshold is 104m/s
2
. The specific configuration needs to be based on actual conditions. The configuration of the active threshold and the static
threshold can be found in the Netvox LoRaWAN Application Command V1.8.6 document.
7. Installation
This product comes with waterproof function. When using it, the back of it can be adsorbed on the iron surface, or the two ends can be fixed to the wall
with screws.
Note: To install the battery, use a screwdriver or similar tool to assist in opening the battery cover.
8.Important Maintenance Instruction
Your device is a product of superior design and craftsmanship and should be used with care. The following suggestions will help you use the warranty
service effectively.
• Keep the equipment dry. Rain, moisture, and various liquids or moisture may contain minerals that can corrode electronic circuits. In case the device
is wet, please dry it completely.
• Do not use or store in dusty or dirty areas. This can damage its detachable parts and electronic components.
• Do not store in excessive heat. High temperatures can shorten the life of electronic devices, destroy batteries, and deform or melt some plastic parts.
• Do not store in a cold place. Otherwise, when the temperature rises to normal temperature, moisture will form inside, which will destroy the board.
• Do not throw, knock or shake the device. Rough handling of equipment can destroy internal circuit boards and delicate structures.
• Do not wash with strong chemicals, detergents or strong detergents.
• Do not apply with paint. Smudges can block debris in detachable parts and affect normal operation.
• Do not throw the battery into a fire to prevent the battery from exploding. Damaged batteries may also explode.
All of the above suggestions apply equally to your device, battery and accessories. If any device is not working properly.
Please take it to the nearest authorized service facility for repair.
