9
F
Model:
Netti
Dynamic Leg support
Language:
English
Version:
2017-05
4.1 Leg support length adjust-
ments
Measure the user’s lower leg length
F
-
90 degrees bent knee - measure from
underside thigh to underside heel of
shoe.
the centre joint of the leg support is
hidden under the knee-joint upholstery.
the illustration with removed upholstery
shows the leg support knee-joint centre
which is to be at the same level as the
knee-joint of the user. adjust the length
of the leg support according to the leg
length measured.
nB! correct seat depth:
loosen the Velcro straps of the back
support. Check that the user is getting
into the chair firmly. adjust the back
support by pulling the straps of the Vel-
cro. the knees of the user should align
with the joint of the leg support both in
height and in depth. this will ensure that
the user gets a good support and pres-
sure distribution under the thighs.
seat depth can be adjusted. extension
pieces allow for increasing the seat
depth in the front. Chair-back hinge
can be repositioned to adjust seat depth
backwards. Consider wheelchair balance.
see further information to seat depth
adjustment in wheelchair user manuals.
4.2 netti Dynamic DUaL: Foot-
board height adjustment
loosen the M6 screws holding the leg
support length-profile on the outside
with 5 mm allen key. adjust the foot-
board to a height from top of front edge
seat cushion to the footboard equal to
the lower leg length -
F
dimension.
4. aDjustiNg the Netti
DYNaMiC leg suPPort
to the user
