NV-202M/S LAN extender with Remote Power
USER’S MANUAL Ver. A.2
22
Appendix A:
Cable Requirements
A.1 Ethernet Cable
A CAT. 3, 4 or 5 twisted pair cable is typically used to connect the Ethernet device to the NV-202M/S. A 10Base-T cable
often consists of four pairs of wires, two of which are used for data transmission and the other two pairs are used for power
transmission. The connector at the end of the 10Base-T cable is referred to as RJ-45 connector and it consists of eight pins.
The Ethernet standard uses pins 1, 2, 3 and 6 for data transmission purposes, power supply uses pins 4, 5 and ground
uses pins 7, 8. (
Table A-1
)
Table A-1
RJ-45 Ethernet Connector Pin Assignments
MDI
MDI-X
PIN #
Signal
Media Dependant
interface
Signal
Media Dependant
interface-cross
1
TX+
Transmit Data +
RX+
Receive Data +
2
TX-
Transmit Data -
RX-
Receive Data -
3
RX+
Receive Data +
TX+
Transmit Data +
4
48V
NV-202S only
48V
NV-202S only
5
48V
NV-202S only
48V
NV-202S only
6
RX-
Receive Data -
TX-
Transmit Data -
7
Ground
NV-202S only
Ground
NV-202S only
8
Ground
NV-202S only
Ground
NV-202S only
Figure A-1 Standard RJ-45 repectacle/connector
Note:
Please make sure your connected cables are with same pin assignment as above table before deploying the cables into your
network.