NV-202M/S LAN extender with Remote Power
USER’S MANUAL Ver. A.2
9
2.4 Connecting the NV-202M and NV-202S
NV-202M power adapters must be connected first before switch can be powered on.
NV-202M/S has one RJ-45 fast
Ethernet port which support connection to Ethernet operation. The devices attached to these ports must support
auto-MDIX and auto-negotiation or 10Base-T OR 100Base-TX unless they will always operate at half-duplex. NV-202S
fast Ethernet port is used to connect to external power splitter(POE) or build in power splitter of networking devices
such as IP CAM, VOIP, wireless AP, sensor scanner or other power splitter(PD side) at least 15W
.
The line port has 1 connector: RJ-45 and terminal block. It is used to connect from NV-202M using single pair phone
cable to NV-202S side(point to point solution). Take note that NV-202M/S line port cannot be used at the same time.
Either RJ-45 port is connected
or terminal block is connected using straight connection (
Figure2.1
)
Figure2.1: NV-202M/S line ports straight connection
