Netkrom W24-AP11H, Руководство пользователя

Страница: 30 / 40

-26-
save
Save your new configuration. Remember that the “save command” is required every time
you make the new configuration.
set default
Return the factory default settings of the Inter-Building Access Point except for the IP
addresses.
A 'save' command is required for changes to take effect.
cls
*
Clear the console screen.
exit
*
Exit the console.
?
*
or help
*
Print a help screen.
rz
*
Receive a firmware file by the Zmodem protocol. The console will enter Zmodem
receiving mode and then use the "file upload" function of your terminal emulation
program to upload a new firmware file (
ap.img
) to the Inter-Building Access Point.
Upon completion, always remember to type the 'reset' command for running the Inter-
Building Access Point with the new firmware.
reset
*
Issue a reset signal. The Inter-Building Access Point will be reset if user confirms.
3-2-2 Advanced Settings for Security
This section describes the commands to control the security for Inter-Building Access Point.
To prevent unauthorized wireless stations from accessing data transmitted over the network,
the 11Mbps Wireless LAN Inter-Building Access Point offers the following levels of security
options.
-
Access Control Table restricts wireless stations to access the Inter-Building Access Point.
- Data Encryption, known as WEP (Wired Equivalency Privacy), encrypts wireless data
transmitted via wireless medium.
Access Control
auth mode | add | del | list| clear
The 'auth' command contains sub-commands that allow you to manage the access control
(MAC address filter) of the Inter-Building Access Point. The access control table consists
of a list for you to control the accessibility of any wireless stations or repeaters. The sub-
commands are listed below: