NETGEAR WAG302 - ProSafe Dual Band Wireless Access Point, Справочное руководство

Страница: 89 / 104

NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual
Command Line Reference C-5
v1.0, May 2006
The
get
,
set
,
add
, and
remove
commands are followed by one or more keywords and might
be followed by one or more optional or required name-value pairs.
You can use CLI commands to view or configure most of the features that you can view and
configure by using the Web UI.
Using the CLI to Configure the WAG302v2 Wireless Access
Point
This section describes the commands you use to view and configure the WAG302v2. The CLI
commands correspond to tasks you can accomplish by using the Web-based user interface (UI). In
some cases, the CLI
get
command provides additional details not available through the Web UI.
config Uploads or downloads the running configuration.
firmware-upgrade Upgrades the firmware.
save-running Saves the running configuration as the startup configuration.
reboot Restarts the access point (a “soft” reboot).
factory-reset Resets the AP to factory defaults and reboots.
Warning: Settings updated from the CLI (with
get
,
set
,
add
, and
remove
commands) will not be saved to the startup configuration unless you
explicitly save them by issuing the
save-running
command.
Note: CLI commands are not available to merge, import, and export the known AP list
for Rogue AP detection feature. Additionally, you cannot set the channel or
frequency by using the CLI.
Table C-3 Commands at the Blank Prompt (continued)
Command Description