NETGEAR WAG302 - ProSafe Dual Band Wireless Access Point, Справочное руководство

Страница: 32 / 104

NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual
2-10 Basic Installation and Configuration
v1.0, May 2006
• Untagged VLAN. You can use VLANS on the WAG302v2 to logically separate traffic
that is on the same physical network. VLAN tagging is always enabled so that the
WAG302v2 can process VLAN membership information.
• By default all traffic on the WAG302v2 uses VLAN 1, which is the default untagged
VLAN. Therefore, all traffic is untagged until you change the untagged traffic VLAN ID
or the VLAN ID for a specific Security Profile. Check the Untagged VLAN check box to
transmit all frames on the specified VLAN as untagged. If you clear the box, all traffic is
tagged with a VLAN ID.
• Time Zone. Select the Time Zone to match your location. If your location uses daylight
saving, check the box Adjust for Daylight Saving Time.
• The Current Time, as used on the wireless access point, is displayed.
• NTP Server. Click Enable to use a network time protocol (NTP) server to synchronize the
clock in your access point, or click Disable if you do not want to use an NTP server.
• Use Custom NTP Server. If you do not want to use the default NETGEAR NTP server,
click this box and enter the hostname or IP address of the NTP server to use.
3. Click Apply to save your settings.
Wireless Settings
To configure the wireless settings, connect to the WAG302v2 and click Wireless Settings in the
Setup section of the WAG302v2 main menu.
The Wireless Settings menu appears, as shown in Figure 2-6 . The figure shows the 802.11b/g radio
configuration.
Note: You must have an Internet connection to get the current time.
Note: The configuration options for the 802.11a radio and the 802.11b/g radio are the
same, but the values are different.The 802.11a and 802.11b/g radios operate on
different channels and frequencies and have different data rates.