Quick Start Guide
APconnections, Inc. // 303.997.1300 //
www.netequalizer.com
Page 5 of 14
All rights reserved
Copyright © 2010 to 2015 APconnections, Inc.
rev. 20141125
Step #2A (required): Configure IP settings
To Change IP settings from the defaults:
Click on ->
Manage NetEqualizer
->
[
Configure IP
Settings
]
. The following screen comes up.
Type in new values to change the
Web GUI IP (
*
BRIDGEIP)
Web GUI Netmask (
*
BRIDGENETMASK)
Web GUI Gateway (
*
BRIDGEROUTE).
(
*
) These are the parameter names shown in the
NetEqualizer Configuration file.
To save your changes,
Click on
-> [
Submit Changes
]
.
To discard your changes,
Click on->
[
Reset
]
.
To have your changes take effect right away,
Click on ->
[
Maintenance
]
->
[
Reboot NetEqualizer
].
Once rebooted, please wait 1-3 minutes for the NetEqualizer process to reload.
To wait until later to have your changes take effect,
Click on ->
[
Later
]
.
Step #2B (recommended): Configure Passwords
We recommend that you change the both the Web GUI Password and the System Root Password.
To Change the Web GUI Password:
Click on ->
Manage NetEqualizer
->
[
Configure
Passwords
]
.
The following screen comes up.
Please note that you can ONLY USE LETTERS AND
NUMBERS. Do NOT use Special Characters.
Once you have set the password,
Click on
-> [
Set Password
]
to save your changes.
If your change was accepted, you should see
"[console] Changing password for user neteq
Your request is complete.
Changes take effect immediately."
Note:
As the old GUI IP address is no longer valid, you will now need to login from your new GUI IP address.
Note:
If you ever forget your web GUI password, you cannot retrieve it from the NetEqualizer. You will need to email
or call us at 303.997.1300 x102 with your Serial # and we will send you the procedure to reset it.
