28
NP285 Turbo HomePlug Ethernet over Power Adaptor
YML798 Rev1
Appendix B: Cable Connections
This cable information is provided for your reference only. Please ensure you only connect
the appropriate cable into the correct socket on either this product or your computer.
If you are unsure about which cable to use or which socket to connect it to, please refer
to the hardware installation section in this manual. If you are still not sure about cable
connections, please contact a professional computer technician or NetComm for further
advice.
RJ-45 Network Ports
RJ-45 Network Ports can connect any networking devices that use a standard LAN interface,
such as a Hub/Switch Hub or Router. Use unshielded twisted-pair (UTP) or shield twisted-
pair (STP) cable to connect the networking device to the RJ-45 Ethernet port. Depending
on the type of connection, 10Mbps or 100Mbps, use the following Ethernet cable, as
prescribed.
10Mbps:
Use EIA/TIA-568-100-Category 3, 4 or 5 cable.
100Mbps:
Use EIA/TIA-568-100-Category 5 cable.
Note: To prevent loss of signal, make sure that the length of any twisted-pair connection
does not exceed 100 metres.
Figure 1
Figure 2
RJ-45 plug
attached to cable
RJ-45 Connector
Pin Assignment
Normal Assignment
1
Input Receive Data +
2
Input Receive Data -
3
Output Transmit Data +
6
Output Transmit Data -
4,5,7,8
Not used
