10
Replacing a Drive Drawer in a 60-Drive Tray
5
Push the drive drawer all the way back into the drive tray, closing the levers on each side of the drive
drawer.
ATTENTION
Risk of equipment malfunction
– Make sure that you push both levers to each side
so that the drive drawer is completely closed. The drive drawer must be completely
closed to allow proper airflow and prevent overheating.
6
Install the bezel on the front of the drive tray.
7
At the rear of the drive tray, check to see if the left fan canister is installed. Is the left fan canister
installed?
Yes
– Go to step
.
No
– Go to step
.
8
Perform these steps:
a
Remove the left fan canister by pressing on the tab holding the handle in place, and then pulling
the handle toward you.
b
Use the handle to pull the left fan canister out of the drive tray.
c
Go to step
9
Connect the left cable chain mounting bracket to the drive drawer.
10
Connect the left cable chain mounting bracket to the midplane. Use a flashlight, if necessary, so that
you can see the connector on the mounting bracket connect to the midplane connector.
11
Reinstall the left fan canister.
12
Remove the right fan canister by pressing on the tab holding the handle in place, and then pulling the
handle toward you.
13
Use the handle to pull the right fan canister out of the drive tray.
14
Connect the right cable chain mounting bracket to the drive drawer.
15
Connect the right cable chain mounting bracket to the midplane. Use a flashlight, if necessary, so that
you can see the connector on the mounting bracket connect to the midplane connector.
16
Reinstall the right fan canister.
17
Remove the antistatic protection.
18
Do you have power applied?
Yes
– The drives will automatically spin up and, if necessary, start to rebuild the volumes.
No
– You are finished with the procedure, and you can turn on the power.
