NESTOR MARTIN M43 Скачать руководство пользователя

Страница: 13 / 24

13 of 24

Fig. 20

3. Place five or six loosely crumpled sheets of

newspaper in the bo�om of the stove. Add a small
amount of dry kindling randomly on the top of the
newspaper. Place a few more loosely crumpled
newspaper on top of the kindling and light the
bo�om paper first, then light the top paper.The
upper fire should preheat the chimney and create an
effec�ve dra� while the lower fire ignites the
kindling.
It is advisable to leave the door ajar for a few
minutes to facilitate the igni�on and avoid
condensa�on, keeping the glass clean. Never leave
the stove una�ended with the door open.

4. Once the fire has started, add increasingly larger

pieces of wood un�l the fire is ac�vely burning.

5. When the fire is well established, slide the

Burn

Type Lever to the top for normal opera�on with
wood (“A”). Then adjust the Burn Rate Knob to the
desired heat output, either manually or with the
remote control. Close the by-pass of the TruHybrid
System, to allow the flue gases pass through the
catalyst (Fig. 21) to achieve the maximum efficiency
of the stove.

Protect your hands for such opera�on.

In addi�on, if you have an op�onal dra� control (fig.
10), you can regulate combus�on by opera�ng its
control

Fig. 21

3.5. RELOADING THE STOVE

To refuel the stove, first slide the Burn Type Lever to its
mid posi�on, and then rotate the Burn Rate Knob to
maximum. Let the fire “liven up” for about one minute.
Open the front door slightly and hold in this posi�on
about 30 seconds or un�l stove is dra�ing well. Open
the front door all the way and rake the embers towards
the front of the stove, spreading them evenly. If there
are logs only par�ally burned, rake these to the front of
stove.
Add fuel. If the fire is almost depleted and a full load of
cordwood is added, it may be necessary to leave the
Burn Rate Knob on the high se�ng for a while to re-
establish a lively fire. Once the fuel is burning at a brisk
rate, slide the Burn Type Lever back to Posi�on A and
turn the Burn Rate Knob down to the desired se�ng.

3.6. OVERNIGHT BURNING

The Burn Rate Knob allows you to adjust the size of the
intake opening, and therefore the tempo of the fire.
Turning the knob to the le� increases air intake,
resul�ng in higher flames and a cleaner burn; Turning
the knob to the right decreases air intake, thus lowering
the flames and prolonging the burn �me.
If you fill your appliance with wood and close the air
supply, you will produce smoke and tar and the window
glass will become dirty.
To keep the glass clean and burn overnight without
producing smoke, we recommend you build up a bed of
charcoal, which will burn cleanly for many hours with
the air flow reduced to a low se�ng, the depth of
charcoal will depend on the length of �me you wish to
run it for. Do not shut the air control completely but
leave it slightly open, depending on how the chimney
draws, to achieve slow burning for a maximum of 8
hours (with dry, good quality wood such as oak…).
With a well-drawing chimney, the air control will need
to be closed further than with poor drawing chimneys.
If your window glass becomes tarred a�er a low burn,
you may burn the tar off of it by using the integrated air
wash system. To do so, turn the Burn Rate Knob to
maximum and run the stove hard with a small charge of
fresh wood.