pg. 8 TQM_057 Effective: September 2016
DESCALING INSTRUCTIONS FOR CS20
IMPORTANT NOTE- Before starting the descaling process
ensure that you have read the safety instructions on the box
and have the following items available:
Descaling Kit:
CS20
– DKB2C2/B2B (use
1 x 100ml pouch
of descaling liquid
each time)
Descaling Tray:
5035/GEMINI (Descaling tray, plastic tube, spanner for steam
nozzle)
1
The machine needs to be completely cold before descaling
.
Unplug machine and let it cool down for about 20 minutes.
2.
Remove milk canister from the machine. Unscrew the nozzle
tip with the red rings clockwise
.
[If available, attach the anti-splatter silicon tube (from
5035/GEMINI descale kit) in place of the nozzle tip.
Alternatively, continue procedure with the nozzle tip
removed.
]
Place a container or descaling tray underneath the milk
spout. Empty container and insert back into the machine.
3.
Fill up water tank with
1 x 100 ml pouch of descaling
solution
diluted with 0.45L of water.
4.
Put the machine in standby mode. The machine should be switched on at the power point. And the
on/off button should be illuminated red. The cup and plus button should be off.
5.
Press and hold cup and plus button until the buttons light up
orange. Descaling solution should start pouring out from
nozzle. (If the buttons are flashing orange alternately this
means the machine is too hot and you need to unplug the
machine and let the machine cool down.)
Important
– If for any reason you need to STOP the
descaling process, press the STANDBY button.
6.
Let all the solution pour out from the nozzle until the machine
automatically stops.
Remove the water tank and drip tray, clean and rinse.
Fill up the water tank with 0.45L of water. Insert water tank
and drip tray back onto the machine. Press the cup button
again to start the rinsing process. Water will pour out and
automatically stop once complete.
[Unscrew anti-splatter silicon tube clockwise (from
5035/GEMINI descale kit) if used]
Re-attach nozzle tip with the red rings by screwing counter
clockwise.
7.
Descaling is now complete and the machine is now ready to be used.
