8
9.
ROLL CARRIER
Laminating materials as well as printed materials are wound on paper tubes of an internal diameter
three inches (76,2mm). The Neschen laminator shafts are designed for these tubes.
If the laminate being unrolled from the shaft is too slack or too tight, the braking force can be
adjusted by turning the head of the bolt on the right hand side of the machine. By tightening the bolt
the braking force is increased, and by loosening it the force is reduced.
If silicone paper fails to wind up, winds up too loosely or too tightly, the shaft resistance can be
adjusted by turning the bolt on the right hand side. By tightening the bolt the resistance is
increased, and by loosening it the resistance is reduced.
10. INSERTING A ROLL OF MATERIAL ONTO THE SHAFT
1.
Remove the shaft from the laminator. Shafts are fastened in the laminator with locks on the
right hand side. Turn the carrier until the lock is released. Positions for materials which are
under the table have their shafts secured with a turn lock. Before removing the shaft, the
lock must be released. Remove first the shaft on the side of the lock.
2.
Insert the roll of material onto the shaft. When handling heavy roles, it is advisable to have
another person.
3.
Replace the shaft back onto the machine in a reverse procedure to the one described in
point 1.
