COR User Guide
Page 6
❖
APEX (2016) systems must have AOS version 5.03_AB17 or newer.
❖
APEX Classic systems must have firmware version 4.53_AB17 or newer.
It is recommended to upgrade your APEX AOS or firmware to the latest available version
even if your APEX currently meets the minimum version requirement.
❖
Refer to the
for instruction about updating the
APEX Operating System to the latest release.
❖
Refer to the
page on Neptune Systems’ web site for instructi
ons
and download of APEX Classic firmware.
WARNING:
Do not connect your new COR-15 or COR-20 driver to your
APEX system until you have verified that your APEX has the required
minimum firmware version or newer, or have upgraded your APEX if needed.
PHYSICAL INSTALLATION
–
COR-15 AND COR-20 DRIVER
The COR-15 or COR-20 driver should be securely mounted in a location free from
moisture. The COR driver uses an innovative mounting system which provides safe
secure mounting yet allows easy removal of the COR from the mounting plate. It is
recommended that the COR driver be mounted on a vertical surface such as a wall, an
upright mounting board, or the side or back of your aquarium stand. Use the included
screws to mount the COR driver mounting plate, then slip the COR over the mounting
plate and press downward to firmly seat the COR driver on the mounting plate. If
mounting on drywall, use drywall anchors (screws and anchors not included). A
printable mounting template is available
. The mounting template contains
additional mounting guidelines.
❖
Be sure to utilize drip loops on all cables plugged into the COR driver.
❖
Leave at least 1” of clearance
at the top of the COR driver to allow for easy
dismounting of the driver.
❖
Leave at least 2.5” of clearance below the COR
driver to allow sufficient room for
cabling
WARNING:
Water damage will void your COR driver warranty! Mount the
COR driver in a location safe from any form of moisture exposure
–
drips,
splashes, etc.
