Neousys Technology Nuvo-8208GC Series, Руководство пользователя, Страница: 84 / 141

Nuvo-8208GC
84
[BIOS POST Check]
Enabled
This option secures a boot-to-OS operation. If the system is
failed to boot to OS (e.g. disk failure or no bootable device)
within 60 seconds, ignition control module will cut off system
power and retry another power on cycle.
Disabled BIOS POST check is skipped.
[Power On Delay]
Specifies the power-on delay duration. Once IGN signal goes active and sustains for the
duration of power-on delay, ignition control module turns on system power and boot up
the system.
[Power Off Delay]
Specifies the power-off delay duration. Once IGN signal goes inactive and sustains for
the duration of power-off delay, ignition control module performs system shutdown
(soft-off) and then cut off system power.
[Hard-off Timeout]
Specifies system hard-off timeout. Once system failed to normally shutdown via a soft-off
operation due to system/application halts (e.g. Windows BSOD), ignition control module
can compulsively cut off system power after the given hard-off timeout.
[Battery Voltage]
Specifies the battery voltage of the vehicle where System VTC is deployed. Typically it’s
12 VDC for sedan and 24 VDC for bus/truck.
[Low Battery Threshold]
When system is running, ignition control module continuously monitors the battery
voltage. Once the battery voltage is lower than the specified threshold, it performs
system shutdown (soft-off) and cut off system power to prevent battery drain-out. You
should specify the low battery threshold according to the given battery voltage.
Press F10 to “Save Changes and Exit”. The ignition control module will be reset and
operate according to parameters configured in BIOS setup menu.