Nuvo-5095GC Series User’s Manual
Copyright © 2017 Neousys Technolgy Inc. All Right Reserved.
65
2. Connect the wafer terminal to the wafer connector on the front panel of the
Nuvo-5095GC controller.
3. Push the non-latched switch will turn on the system (the PWR LED indicator on the
front panel is on at the same time). Push the non-latched switch when system is on will
turn off the system. If your operating system supports ATX power mode (i.e. Microsoft
Windows or Linux), push the power button causes a pre-defined system behavior, such
as shutdown or hibernation.
3.10.3
Power on Nuvo-5095GC Using Wake-on-LAN Function
Wake-on-LAN (WOL) is a mechanism to wake up a computer system from a S5 (system off
with standby power) state via issuing a magic packet. Nuvo-5095GC series implements the
Wake-on-LAN function for the GbE port marked below.
To enable WOL function and power on you Nuvo-5095GC controller, please follow the
steps described below.
1. When Nuvo-5095GC controller boots up, press F2 to enter BIOS setup utility.
2. Enter the
[Power]
menu. And configure the
[Wake On LAN]
option as
[Enabled]
.
This setting enables the Wake-on-LAN function for Nuvo-5095GC series. Please refer
to section 4.1.5 for the instruction of configuring this BIOS option.
