16
5 Software Setup E
5.3.2 Channel 2 installer menu
The installer menu for channel 2 is exactly the same as for Channel 1.
Refer to 3.3.1.
5.3.3 Log repeat interval
•
If a log event recurs within this interval time, only the first instance will be
logged and all subsequent identical events will not be recorded.
•
To change the hours value, press the centre pushbutton and increase or
decrease the value. Press the centre pushbutton again to select the hour
value and move to the minute value. Press the centre pushbutton to select
the value.
•
Note that the change needs to be saved before it will take effect
(see 3.3.4).
5.3.4 Set TW Node address
•
Set the network address, from 1 to 63, for the Node.
•
This is the address of the Node that will be displayed on the FG7 network
controller and Fenceprobe software, and should not be confused with the IP
address. For more information, refer to the NEMTEK Network Guide.
5.3.5 Save configuration
•
All configuration changes in the installer menu need to be saved before the
changes will take effect.
•
Hold the centre pushbutton for 2 seconds to save the current configuration.
5.3.6 System restart
See 3.2.7
