6
security reasons they have no default codes and must be assigned by the
master user.
A reset user may only reset the alarms but not change the On/Off state of the
energizer. User #4,#5,#6. For security reasons they have no default codes
and must be assigned by the master user.
The embedded Linux platform will be made commercially available during
2007 that will provide connectivity to the energizer and a history of all events
including user intervention. The three different users in the normal operators
allows for three eight hour shifts to be monitored.
The energizer will restore its condition to its previous state should there be a
total power failure i.e. mains failure and battery flat.
Note that the
Gate inputs are active even when the energizer is switched off
.
Use the Gate Bypass function if these inputs are to be ignored.
USING YOUR KEYPAD
SWITCH THE FENCE ON / OFF (Master/Normal User)
To switch the fence On or Off, enter your four digit PIN followed by the
#
key. If the red ON
light is lit or flashing, the fence is energized.
•
Don’t pause for more than 5 seconds while entering the digits, or the control panel
will reject your PIN number.
•
If you make a mistake while entering your PIN, press the
#
key and start again.
•
An incorrect PIN will cause the control panel to beep 5 times.
The default master (User # 0) PIN is
1 2 3 4
.
AFTER AN ALARM OCCURS
Enter your PIN (all users) and press the
#
key. This will silence the buzzer and siren. It will
switch the fence off. One of the
ALARM
lights will flash or stay lit to indicate the source of
the alarm. A flashing indicator illustrates that the fault condition persists. A permanently lit
MERLIN STEALTH
M113S
Using your KEYPAD
PDF created with pdfFactory trial version
www.pdffactory.com
