10
MANUAL BATTERY TEST
Enter your PIN (master only) and press the
*
key, enter the digit
6
, then press the
#
key.
The keypad will beep four times indicating the battery test has started. This test disables the
mains input for 20 minutes and monitors the battery voltage. If the battery voltage falls
below an acceptable level during this test the battery service light will come on, provided the
bypass is not enabled, and indicates the battery needs replacing. It is advisable to have the
energizer running in High Voltage mode during this test. It is advisable to test battery
condition at least twice a year. (If the auto battery test feature is enabled by the installer, the
timing sequence will be re-initiated.)
CHANGING A USER PIN
Enter your master PIN, press the * key, enter the digit 0, then press the # key. Enter the
user number (0-6), and push the # key. User number 0 is the master PIN that has system
configuration rights i.e. bypass of alarm conditions etc. Enter that user’s new PIN and press
the # key. Enter the new PIN again and press the # key. If the new PIN is accepted, the
control panel will beep four times. If you make a mistake while programming, or if the
system rejects the new PIN, the control panel will beep five times.
ALTERING THE KEY-PAD INDICATOR BRIGHTNESS
:
The brightness of the keypads can be increased or decreased by pressing and holding the 1
or 7 keys respectively. The key-pad will beep while the indicator brightness is changing. No
user PIN is required for this operation.
Master PIN
User (0-6)
New PIN
New PIN
MERLIN STEALTH
M113S
Using your KEYPAD
PDF created with pdfFactory trial version
www.pdffactory.com
