Operation without a keypad
9
Activating and deactivating the energizer
Unless this feature has been disabled by the installer, the energizer can be
activated or deactivated by presenting the Nemtek plastic tab over the
corresponding logo on the fascia of the unit. Remove the tab when the
energizer produces a short beep, after which the energizer will toggle its operating
state. The energizer can also be configured to use a remote switch.
Acknowledging and silencing an alarm condition
Present the Nemtek plastic tab over the corresponding logo on the fascia of the
unit. An initial short beep will be heard as the tab is detected, but keep holding the
tab in place until a second longer beep is heard. The siren will be silenced if not yet
timed out, the internal beeper will stop sounding and the strobe will be
deactivated. One of the alarm
, alarm history
or event
symbols will
indicate the source of the alarm.
Clearing an alarm or event from memory
An alarm symbol indicates that the condition persists and will have to first be
corrected. An alarm history symbol indicates the fault no longer exists and
simply turning the energizer off and on again, or presenting the tab until the long
beep is heard, will clear the memory condition. Only if the alarm condition is
resolved will the energizer operate without alarm activation.
t
