3
Nemschoff for Palisade 2.0
Assembly Instructions
1BP8JN rev A
Step 7
Step 8
7.1 Insert set screw into the access panel.
7.2 By using 3 flat washers and 3 round head machine screws (0.5”
long), install the access panel as shown below.
8.1 Install the table assembly in between the 2 seat booth by using 6 flat
washers and 6 round head machine screws (0.625” long), (4 at the bottom
and 2 at the back) as shown below.
Round head
Machine Screw
Round head
Machine Screw
Round head
Machine Screw
Table Assembly
Flat
Washer
Flat
Washer
Flat Washer
Access Panel
Set Screw
Access
Panel
Step 2
867H-L Seat Booth
Step 1
1.1 Feel for hole with finger, then carefully cut with sharp utility knife by
using approximate measurement given below.
1.2 Remove fabric from area around bracket mounting hole location, top
bracket mounting locations. Take care not to extend fabric cuts more than
¼ inch from hole center.
(This Step is supposed to be done in the factory but just in case
here is what needs to be done)
7-5/8”
1-3/4”
Utility Knife
2.1 Install the back tube by using 2 flat washers and 2 round head machine
screws (2” long) (2 at the bottom and 2 at the end of tube).
Flat Washer
Flat Washer
Round head
Machine Screw
Round head
Machine Screw
Back Tube
