Nemaxx PW18, Инструкция по эксплуатации

Страница: 22 / 122

Version: 2.0
KEN002PW18 25.11.2019
[ EN
● 22 ]
IMPORTANT!
During the flame switching off phase and exchanger cooling, Normally it isn't allowed to switch on
again the heater up to the operation end; this state is highlighted from the message 'SWITCHING OFF'.
HOWEVER, It is possible to switch off the heater in every functioning phase. The switching off performs pres -
sing the key ON/OFF for two seconds, make sure the stove is under your eyes , until its 'Stabilisati -
on'. After push the button, then the phrase 'Cooling' comes.
After the stove's temperature falling down, the stove starts again, Cleaning-feeding-lighting-stabilization.
How to make the stove immediately skip the process to Stabilization. During the first several stages when you
think the flame is ok and/or the stove can work properly?
Push for 3 seconds, and then it will turn on Stabilization directly.
If the heater is switched off, the flame will continue to be present up to the fuel exhaustion contained in the
melting pot, this phase will manage in automatic way both fans and it will have the duration up to 5-8 minutes.
The switching off phase is displayed from the message 'SWITCHING OFF' present up to the end of the operation.
Whether the heater is switched or not, on the display will display the hour, the power, and the planned set
temperature.
Note: If the new stove, when its first time using, it is necessary to put a hand of pellet to the fire pot
before hand.
Note: if the ignition is failure, the thermal control will shut off the stove automatically. Meanwhile, E2 (Error for the
ignition failure), will be turned on the display, If want to restart it again, Please Check the stove as usually and
cleaning the fire pot. After that, you have to push to clean the Phrase E2. Follow the above process to
ignite and start again.
IMPORTANT!