ADVANCED FEATURES
The
EZ Pro™
incorporates three manual/test procedures for checking the function of the
controller or allowing you to bypass the current program to water immediately. The following
section will show you how to set up the controller to:
•
run a zone manually
•
run a program manually
•
run a 3 minute test of every programmed zone
NOTE: All test procedures are run with the MODE dial in the AUTO position. This allows
the controller to reset to the AUTO setting after running a manual/test procedure.
It also allows you the ability to walk away from the controller after setting up a
manual/test procedure and not have to come back to reset the controller to
AUTO.
NOTE: All manual/test procedures ignore the sensor connection. Therefore, you can
water utilizing one of the manual/test procedures even if the sensor has
suspended your scheduled program.
Run a Zone Manually
Turn the large dial to the
MANUAL
position. The default of zone 01 and 00:10 minutes will be
flashing (recall that this means you can change them). Press
SELECT
to select the zone
number that you want to run. Press
ADJUST
to set the run time for the selected zone.
The controller will delay 5 seconds before starting the zone.
19
