Nelsen Corporation Aqua Classic, Инструкция по установке, эксплуатации и обслуживанию

Страница: 10 / 20

-8-
3) Turn off feed water valve and tank valve and set
tank aside (15 minutes min).
D. Install the Drain Connection
NOTE:
For Basement Installation See Figure 6,
Page 16.
Under counter Installations:
IMPORTANT:
Before starting this pro ce dure,
inspect the condition of the drain
piping, especially in older homes
where the traps and tailpieces can
be deceptively thin and frail. If in
poor condition, the condition
should be remedied.
The drain saddle assembly is de signed to fit around a
standard 1-1/2" OD drain pipe.
The drain saddle should always be installed above
(before) the trap and on the vertical or horizontal
tailpiece. Never in stall the drain saddle close to the
outlet of a gar bage disposal or plugging of the RO drain
line may occur. See Figure 4.
1) Position threaded half of drain saddle at selected
lo ca tion and mark the spot through the opening.
See diagram.
2) Drill a 1/4" hole at the marked spot through one
side of drain tail piece.
3) Position both halves of drain sad dle on drain pipe
so thread ed opening lines up with the hole in
drain pipe.
4) Use bolts and nuts to clamp drain saddle onto
drain pipe. Do not over tight en and make sure
there is equal space between saddle halves on
each side. See diagram.
5) Wrap teflon tape on thread of “John Guest” fitting
and tighten into drain sad dle.
E. Make Initial Tubing Connections
NOTE:
For Basement Installation See Figure 6,
Page 16.
Under counter Installation:
1) It is advantageous to make some of the tubing
con nec tions at this time, since the under-sink
work area is not so cramped and access to the
com po nents is easier. If nec es sary, refer to the
enclosed diagram on use of the “John Guest”
plastic fittings.
2) The orange 3/8" tubing should already have been
con nect ed to the feed water valve with a 3/8"
brass com pres sion nut, in sert and plastic sleeve.
3) Tighten 3/8" plastic “John Guest” fitting onto
threaded faucet nipple. No Teflon tape is required
to make an ef fec tive seal. It may be necessary to
hold faucet from turning while tightening fit ting.
4) Route black 3/8" tubing from faucet air gap to
drain saddle so that it slopes con tin u ous ly down-
ward with out loops or low spots. Cut to proper
length and con nect to “John Guest” drain fitting.
F. Install the Purification Assembly &
Storage Assembly
NOTE: For Basement Installation See Figure 6,
Page 16.
Under counter Installation:
The purification assembly is usually mounted to the
right or left sink cabinet sidewall, taking into con sid er-
ation the space available and the tank lo ca tion. Gener-
ally, the tank is placed in the rear of the cabinet while
Drain Pipe
Drain Clamp
Front Plate
“John Guest”
Locking Clip
1/4" Screw 1/4" Nut
“John Guest”
Fitting
1/4" Drilled Hole
FIGURE 4 Feed Valve Installation
Nelsen
Corporation