Neles Easyflow RNP Series, Инструкция по установке, обслуживанию и эксплуатации

Страница: 6 / 28

IMO-218 EN - Issue 8/2020 6
1.5 RECYCLING AND DISPOSAL
Most of the actuator parts can be recycled if sorted according
to material. Most parts have material marking. A material list is
supplied with the actuator. In addition, separate recycling and
disposal instructions are available from the manufacturer. An
actuator can also be returned to the manufacturer for recycling and
disposal against a fee.
1.6 DEFINITIONS
The following definitions given here are used in this document:
WARNING:
IF NOT OBSERVED, USER INCURS A HIGH RISK OF
SEVERE DAMAGE TO THE PRODUCT AND/OR FATAL
INJURY TO PERSONNEL.
CAUTION:
IF NOT OBSERVED, USER MAY INCUR DAMAGE TO
THE PRODUCT AND/OR INJURY TO PERSONNEL.
NOTE:
ADVISORY AND INFORMATION COMMENTS PROVIDED
TO ASSIST MAINTENANCE PERSONNEL TO CARRY
OUT MAINTENANCE PROCEDURES.
WARNING FOR ATEX:
IF NOT OBSERVED, USER INCURS A HIGH RISK OF
SEVERE DAMAGE TO ACTUATOR AND/OR FATAL
INJURY TO PERSONNEL.
NOTE:
ADVISORY AND INFORMATION COMMENTS PROVIDED
TO ASSIST MAINTENANCE PERSONNEL TO CARRY
OUT MAINTENANCE PROCEDURES.
WARNING FOR ATEX:
IF NOT OBSERVED, USER INCURS A HIGH RISK OF
SEVERE DAMAGE TO ACTUATOR AND/OR FATAL
INJURY TO PERSONNEL.
1.7 SAFETY PRECAUTIONS
CAUTION:
DON’T EXCEED THE PERMITTED VALUES!
EXCEEDING THE PERMITTED PRESSURE VALUE
MARKED ON THE ACTUATOR MAY CAUSE DAMAGE
AND LEAD TO UNCONTROLLED PRESSURE RELEASE
IN THE WORST CASE. DAMAGE TO THE EQUIPMENT
AND PERSONAL INJURY MAY RESULT.
CAUTION:
DON’T DISMANTLE A PRESSURIZED ACTUATOR!
DISMANTLING A PRESSURIZED ACTUATOR LEADS TO
UNCONTROLLED PRESSURE RELEASE. SHUT OFF
THE SUPPLY PRESSURE AND RELEASE PRESSURE
FROM THE CYLINDER BEFORE DISMANTLING THE
ACTUATOR. OTHERWISE, PERSONAL INJURY AND
DAMAGE TO EQUIPMENT MAY RESULT.
CAUTION:
FOLLOW THE INSTRUCTIONS GIVEN ON THE
ACTUATOR WARNING PLATES!
CAUTION:
BEFORE OPENING THE CYLINDER FASTENING
SCREWS (11), RELEASE SPRING TENSION DIRECTED
ON ACTUATOR WARNING PLATE AND IN THESE
INSTRUCTIONS!
CAUTION:
DON’T DISMANTLE THE SPRING MODULE!
DO NOT REMOVE THE SPRING MODULE WHILE THE
SPRING IS COMPRESSED OR UNDER PRESSURE.
CAUTION:
TAKE THE WEIGHT OF THE ACTUATOR OR VALVE
COMBINATION INTO ACCOUNT WHEN HANDLING IT!
LIFTING LUGS ON THE ACTUATOR ARE MEANT ONLY
FOR LIFTING ACTUATOR AND NOT COMPLETE VALVE
ASSEMBLY.
DO NOT LIFT THE VALVE COMBINATION FROM
THE ACTUATOR, POSITIONER, LIMIT SWITCH OR
THEIR PIPING. LIFT THE ACTUATOR AS DIRECTED
IN SECTION 2, LIFTING ROPES FOR A VALVE
COMBINATION SHOULD BE FASTENED AROUND IT.
THE WEIGHTS ARE SHOWN IN SECTION 9. DROPPING
MAY RESULT IN PERSONAL INJURY OR DAMAGE TO
THE EQUIPMENT.
WARNING FOR ATEX:
WHILE LIFTING ACTUATOR HOUSING SHOULD NOT
IMPACT ON THE OTHER LIGHT OR RUSTY METAL .
CAUTION:
POTENTIAL ELECTROSTATIC CHARGING HAZARD, DO
NOT RUB SURFACE WITH DRY CLOTH.
WARNING FOR ATEX:
INSPECT FOR PAINT DAMAGED, TO ENSURE
CONTINUED CORROSION PROTECTION.
ACTUATOR SPEED SHOULD NOT FASTER THAN
SPECIFIED IN THE FOLLOWING TABLE 4.