13
3
Press the key of the receiver at the
third blink.
x 3
4
If the erase was successful, the receiver will emit 3 short
blinks and 3 beeps.
x 3 +
x 3
5
End
ERASING THE RADIO REMOTE CONTROL MEMORY
Step
Description
Example
1
Press and hold the programming button of the MINI-RX
until the LED of the receiver blinks once and the buzzer
emits one beep.
> 3s
x 1 +
x 1
2
About 1 second after the button is released the LED on
the receiver blinks 5 times.
x …
3
Press the key of the receiver at the
fourth blink.
x 4
4
If the erase was successful, the receiver will emit 5 short
blinks and 5 beeps.
x 5 +
x 5
5
End
ERASING A SINGLE RADIO REMOTE CONTROL
Step
Description
Example
1
Press and hold the programming button of the MINI-RX
until the LED of the receiver blinks once and the buzzer
emits one beep.
> 3s
x 1 +
x 1
2
About 1 second after the button is released the LED on
the receiver blinks 5 times.
x …
3
Press the key of the receiver at the
fifth blink.
x 5
4
Press the key of the radio remote control that you want to
erase.
14
5
If the cancellation was successful, the receiver will emit 5
short blinks and 5 beeps.
x 5 +
x 5
6
To erase an additional transmitter, repeat step 4.
7
To end the procedure, wait for the time-out of 10 seconds.
8
End
SELECTING THE DEVICE MODE
(Warning! The radio remote controls in memory will also be erased)
Step
Description
Example
1
Press and hold the programming button of the MINI-RX.
The LED of the receiver blinks once and the buzzer emits
one beep.
Hold the programming button of the MINI-RX pressed.
The LED of the receiver blinks again and the buzzer emits
another beep.
> 3s
x 1 +
x 1
> 3s
x 1 +
x 1
2
Press briefly and release the programming button once;
the buzzer emits 1 beep: →
Lights mode.
Press briefly and release the programming button again;
the buzzer emits 2 beeps: →
Motor mode
.
Press briefly and release the programming button again;
the buzzer emits 1 beep: →
Roll back to lights mode
.
The system will indicate the selection just made to the user
every 2 seconds through the LED with a number of (fast)
blinks and beeps equal to the selected function.
x …
x … +
x …
3
To conclude the selection, press and hold the
programming button.
The LED of the receiver blinks once and the buzzer emits
one beep.
> 3s
x 1 +
x 1
4
End
PROGRAMMING OUTPUTS 1 and 2
(LIGHTS mode only)
Step
Description
Example
1
Press briefly and release the programming button of the
MINI-RX 3 times (
4 times for output 2)
.
The LED of the receiver blinks 3 times
(4 for output 2)
and
the buzzer emits 3 beeps
(4 for output 2)
every 2 seconds.
x 3 (x4)
x 3 (x4) +
x 3 (x4)
