6
2 Check the table bracket if it is moving smoothly up and down.
3 Check if the spindle shaft moves smoothly.
To adjust table up or down,loosen column lock
handle(A)then turn crank handle(B)to desired
height.Re-tighten column lock handle (A) before
drilling operation.
To swing table 360 loosen column lock handle
(A)then swing table to appropriate
position,re-tighten column lock handle. For long
work pieces swing table 180 and use the base as
your table.
To rotate table 360 loosen table lock handle
(C),rotate table to desired position
and re-tighten table lock handle (C).
To tilt table ,loose the pivot bolt ,Remove the
small locator pin To do this "tighten" the nut until
the pin easily slips out . Tilt the table to the
desired angle up to 45 and re-tighten bolt
Reinsert the locator pin when returning the table
to zero degree.
To stop drill at desired depth,loosen scale set
handle(E) located on feed shaft
assembly, rotate spindle depth to desired depth
and tighten scale set handle.
To hold a stationary depth,loosen scale set
handle (E)turn feed shaft to lowest
point then rotate spindle depth to desired depth
and re-tighten scale set handle.This
will hold the spindle assemble stationary at
desired depth.
Slide small end of arbor into the chuck,place long
end inside spindle hold crank table 5 inches from
tip of spindle,open chuck completely pull feed
shaft down pressing the chuck against the table
till arbor is secure.
TABLE ADJUSTMENT
SPINDLE ADJUSTMENT
DRILL CHUCK AND ARBOR
