5
receptacles that accept the tool's plug.
6. Repair or replace damaged or worn cord immediately.
7.This tool is intended for use on a circuit that has an outlet that looks like the one
illustrated in sketch A . The tool has a grounding plug that looks like the plug
illustrated in Sketch A, A temporary adapter, which looks like the adapter illustrated
in Sketches B and C may be used to connect this plug to a 2 - pole receptacle as
shown in Sketch B if a properly grounded outlet in not available. The temporary
adapter should be used only until a qualified eletrician can installed a property
grounded outlet , the green colored rigid ear, lug, etc. extending from the adapter
must be connected to a permanent ground such as a properly grounded outlet box.
ASSEMBLY
When assembling unit, refer to drawings for part location. (Please see diagram on
page 9 and 10).
1. Bench Drilling Machine
a. Open the box and take out the base(No.1), working table (No.7or 8) and column
(No.2) assembly place it on a flat surface.
b. Take out the head (No.23) and assemble to the column (No.2).
c. Assemble the handle bar(No.31) and gripe (No.32) then screw it in the handle
body (No.30).
2. Floor Type Drilling Machine
a. Open the box and take out the base(No.l) and place it on a flat floor.
b. Take out the column (No.2) with bracket (No.5)and screw it on the base (No.1).
c.Take out the bead (No.23) and assemble to the column (No.2).
d.Then use the allen key for tightening the headless set screw (No.5).
e.Bring out the handle bar (No.31 ) and gripe (No.32) then screw it in the handle body
(No.30).
If any parts are missing, do not attempt to assemble the drilling machine plug in the
power cord or tum the switch until the missing parts are obtained and installed
correctly. Upon completion of assemble.Drilling machine can be washed with
kerosene to remove anti-rust oil applied at factory then lubricating oilcan be applied.
INSTALLATION
Install your tapping & drilling machine in flat, sturdy floor or surface.
1. Check if the tapping & drilling machine is shaking when the motor is switch"ON
