4
6. Be sure chuck key is removed from the chuck before turning on power.
7. Adjust the table or depth stop to avoid drilling into the table. Shut off the power
remove the drill bit on cutting tool and clean the table before leaving the machine.
8. Do not operate until it is completely assembled and installed according to the
instructions.
9. If any part of your drill press in malfunction or has been damaged or broken, do not
operate until the part is properly repaired or replaced.
10. Never place your fingers in a position where they could contact the drill or other
cutting tool if the workpiece should unexpectedly shift.
11. Never use your hand to hole on the object while drilling, always screw the object
tight on the working table or use the drill vise to prevent accident injury.
12. Never perform any operation by moving the head or table with respect to one
another. Do not pull the motor switch “ON” or start any operation before checking
the head and the table lock handles are clamped tight to column, and head and
table support collars are correctly positioned.
13. Before pulling the motor switch "ON" be positive the belt guard is down the chuck
is installed properly.
14. Lock the motor switch when leaving the drill press. Do not perform layout,
assembly or setup work on the table while the cutting tool is rotating.
VOLTAGE WARNING
1. Before connecting the tool to a power source (receptacle, outlet, etc. ) Be sure the
voltage supplied is the same as the rating on the tool motor.
2. A power source with voltage greater than that specified for the tool can result in
serious injury to the user.
3. If you're unsure of the voltage rating do not use tool. Also using a power source
with voltage less than that required for the tool will harm the motor.
GROUNDING INSTRUCTIONS
1. In the event of a malfunction or breakdown, grounding provides a path of least
resistance for eleetric current to reduce the risk of electric shock. This tools is
equipped with an electric cord having an equipment - grounding conductor and a
grounding plug. The plug must be plugged into a matching outlet that is properly
installed and grounded in accordance with all local codes and orinances.
2. Do not modify the plug provided, if it will not fit the outlet, have the proper outlet
installed by a qualified electrician.
3. Improper connection of the equipment - grounding conductor can result in a risk of
electric shock. The conductor with insulation having an outer surface that is green
with or without yellow stripes is the equipment - grounding conductor. If repair or
replacement of the electric cord or plug is necessary, do not connect the equipment
- grounding conductor to a live terminal.
4. Check with a qualified electrician or serviceman if the grounding instructions were
not completely understood, or if in doubt as to whether the tools is properly
grounded.
5. Use only 3 - wite extension cords that have 3 - prong grounding plugs and 3 - pole
