6
12. Connecting the 2 wheel supports by eight M8X20 Hex Bolts, Flat Washer Ø8, Lock Washer Ø8 and
M8 Nuts.
13. Assemble the axle through the wheel support as shown in
Figure 5.
14. Apply grease to the ends of the axle now or use a grease gun after the wheels are assembled.
15. Assemble a Ø20 flat washer , a wheel ( valvestem out) ,another Ø20 flat washer and a cotter pin to
each end of the axle as shown in
Figure 5.
16. Assemble a hub cap over the Ø20 flat washer on each end of the axle as shown in
Figure 5.
17. Stand the cart on end, front end facing up.
18. Assemble the two front axle supports to the cart using twelve M8X16 round head bolts , Flat Washer
Ø8, Lock Washer Ø8 and M8 hex nuts as shown in
Figure 6
.
Do not tighten yet.
19. Place the front axle channels between the front axle supports. Assemble two M8X65 hex bolts
through the holes in the ends of the supports and secure with Ø8 lock washer, Ø8 Flat Washer and
M8 hex nuts. Don’t tighten. See
Figure 7.
20. Assemble the tongue reinforcement angle to the back side of the axle supports as shown in Figure 8.
Use two M8X65 hex bolts,Ø8 lock washer, Ø8 Flat Washer and M8 hex nuts. Don’t tighten.
21. Make sure the center bolt (pivot bolt ) is inserted as far as possible through the axle channels and
then tighten the four bolts assembled in
Figure 8
,which fasten the front axle supports to the cart bed.
22. Connecting the front panel with the bottom panel by using six M8X16 round head bolts, Ø8 lock
washer, Ø8 Flat Washer and M8 hex nuts. Then Connecting the front panel with the side panel by
using six M6X16 round head bolts, Ø6 lock washer, Ø6 Flat Washer and M6 hex nuts. See
Figure 9
.
FIGURE 3
FIGURE 5
FIGURE 6
FIGURE 4