CLEANING/REPLACING
1.
Fig
17
Press the release catch and
unscrew the condensation
chamber, see Fig 1
7
.
2.
Fig
18
Unscrew the filter as shown in
Fig 1
8
and wipe clean
3. Refit the condensation chamber.
REPLACING THE NOZZLE
NOTE:
ONLY use identical replacement parts when servicing.
After l0-l2 hours of blasting time the nozzle should be checked for wear. The
nozzle will wear out over time and should be replaced when the hole is no
longer round or the abrasive media does not flow smoothly through. To
replace the nozzle:
1.
Disconnect the sandblasting gun from the air hose.
2.
Unscrew the nozzle adapter (38), located at the front of the sandblasting
gun.
3.
Remove the old nozzle (37).
4.
lnsert new nozzle.
• A pack of 4 Replacement nozzles are available .
5.
Replace the nozzle adapter (38) and firmly screw it onto sandblasting gun.
• Keep your sandblaster clean and protect it from damage.
• Check for worn abrasive hose and fittings. Watch for leaks, blistering,
bulging or thinning of the hose.
• Replace any parts which appear worn.
4. Check the safety valve every
working hour, clean it up if any clog
happen, and always ensure the
valve works fine.
14
